mbentlyesq
Weekender RV’er
No matter where you go, there you are.
Posts: 65
|
Post by mbentlyesq on Mar 7, 2021 22:05:51 GMT -5
Hey Folks; Does anyone use the LevelMatePRO in their trailer? If so, please share our experiences with getting it mounted and its general use. Thank you. logicbluetech.com/levelmatepro/
|
|
Jim
Seasonal RV’er
Ready to Camp!
Posts: 210
|
Post by Jim on Mar 9, 2021 12:37:29 GMT -5
I've used it to check level. Still getting used to it however after being spoiled by the automatic leveling we had on the Montana Mobile Mansion. LevelPro so far seems to work pretty good on initial set up after unhooking. I do like the jack postion memory. It was already installed in our 333VFK Touring.
|
|
|
Post by WrkrBee on Mar 9, 2021 17:09:34 GMT -5
It just seems too easy to level a travel trailer to throw tech at it. With the stick on levels, after a few setups, you know it's going to take one or two blocks to level side to side. Disconnect, adjust the tongue for end to end level, stabs down, done.
|
|
Jim
Seasonal RV’er
Ready to Camp!
Posts: 210
|
Post by Jim on Mar 11, 2021 16:29:58 GMT -5
It just seems too easy to level a travel trailer to throw tech at it. With the stick on levels, after a few setups, you know it's going to take one or two blocks to level side to side. Disconnect, adjust the tongue for end to end level, stabs down, done. Yeah I got ya .. this tech thing...I do use a 4' level just as a "check" to see if the LevelPro gadget worked. Just old school me, if it takes two nails, I put in a third one..lol.
|
|
|
Post by woodet on Mar 15, 2021 11:31:52 GMT -5
It came preinstalled on my 2020 343VBH, and I love it. I use Andersen Hitches leveler ramps. When I get the trailer about where I want it, I put the leveler ramps under the side I want raised, then back onto them while watching the app on my phone. As with any leveling method you use, getting the trailer to the right orientation while it's closed up is the trick. The slide-outs will likely pull the trailer to one side. It took us a few trips to get the LevelMatePRO zeroed at just the right orientation.
|
|
mmorgan
Newbie RV’er
experienced RVer's with a new sporttrek Stt302VRB in the great Pacific Northwest..
Posts: 15
|
Post by mmorgan on Apr 6, 2021 21:10:30 GMT -5
Our sporttrek had tge levelmate pro factory installed. It was in the rear bathroom on the wall. It looked like a switch plate with a small black button on it for pairing. Not sure where they mounted the sensor. Down load the app on cell phone. Once set up and paired, it works pretty darn good
|
|
mbentlyesq
Weekender RV’er
No matter where you go, there you are.
Posts: 65
|
Post by mbentlyesq on Apr 13, 2021 0:25:24 GMT -5
I just heard from the dealer and our 2021 STT312VBH arrived from the factory today. It comes with the Levelmate Pro installed.
|
|
mmorgan
Newbie RV’er
experienced RVer's with a new sporttrek Stt302VRB in the great Pacific Northwest..
Posts: 15
|
Post by mmorgan on Apr 13, 2021 10:34:06 GMT -5
Hi mbently, a word of advice. Check the control board on new RV and make sure its not the “ irv” board. Also check operation of slideouts on battery only. As there has been issues with this set up! Mine included. We bought the 302vrb and having issues with that set up. Love the coach, but I did not buy. “ shore power rv only. Thats what the factory is trying to tell us. End redult on ours is still pending. Could be law suit in the near future!
|
|
mbentlyesq
Weekender RV’er
No matter where you go, there you are.
Posts: 65
|
Post by mbentlyesq on Apr 15, 2021 0:39:23 GMT -5
Check the control board on new RV and make sure its not the “ irv” board. Also check operation of slideouts on battery only. As there has been issues with this set up! Mine included. We bought the 302vrb and having issues with that set up. Love the coach, but I did not buy. “ shore power rv only. Thats what the factory is trying to tell us. End redult on ours is still pending. Could be law suit in the near future! 1) What is the issue with the IRV board? 2) Are you unable to move the slide outs on battery only power?
|
|
xxxxx
Seasonal RV’er
Posts: 229
|
Post by xxxxx on Apr 15, 2021 6:54:23 GMT -5
Check the control board on new RV and make sure its not the “ irv” board. Also check operation of slideouts on battery only. As there has been issues with this set up! Mine included. We bought the 302vrb and having issues with that set up. Love the coach, but I did not buy. “ shore power rv only. Thats what the factory is trying to tell us. End redult on ours is still pending. Could be law suit in the near future! 1) What is the issue with the IRV board? 2) Are you unable to move the slide outs on battery only power? Howdy, IRV is the make of the control panel that has been shipping with units (I assume yours will have the same). When you check out the camper be sure to run off battery with slides, etc. Some wiring issues have shown up on campers running off of battery (for us not able to run off battery). In one situation I believe it ended up being the fuse in the tongue but they were in the process of working on it. In my case, still working on it. Dealer says they've checked everything... now running a test wire direct from battery to panel (thinking the existing wire has a bad connection). If that doesn't do it will replace board I believe on IRV panel. Anyway, I've posted under General RV Questions with 12 volt issue. Just a warranty item that a few of us have run into. Our monitor panel times in and out when trying to get slide out on battery. So telling folks to be sure to check it out on new units. I love out STT272VRK and they'll get it fixed :-). We're camping with shore power this year so we've been able to camp and really enjoy our new unit. Oh fyi... I had a leak test done while in for warranty work... the Venture unit showed no bubbles.. it was tight.
|
|
mbentlyesq
Weekender RV’er
No matter where you go, there you are.
Posts: 65
|
Post by mbentlyesq on Apr 20, 2021 11:30:21 GMT -5
Thank you B&N.
|
|
|
Post by chrisyoung on Apr 29, 2021 0:27:25 GMT -5
Levelmate has come standard on all Sporttrek trailers since April 201i. Sure, you can use a 6' level, or bubble gauges, but you have to get out of the vehicle a lot of times to "get it right". With LMP, Once out to turn it on, an assistant to tuck your Anderson blocks under the low side, a bit of accelerator and YOU see that it is level. Much easier and faster than a bar or bubble level. And I don't miss the arguments with the wife, either!
|
|