|
|
Post by skip12 on Mar 14, 2024 21:25:43 GMT -5
I was under my 2020 version 200VML looking for the lowest drains and I found them both to be foamed into the side of the black water emptying line. They are so tight in there they wont move I cant seem to separate the hot from the cold. Or away from the 4 inch drain. Does anyone else have the same location? I just bought this a month and a half ago and since I live in Canada Just south of Detroit michigan Its been to cold to look it over. Anyway just wondering if this is the normal location. It does have the weather guard heating set up as well. The other drain for the fresh water is over by the freshwater tank. These are a foot behind the rear axle and hard to get at. ![]() Attachments:
|
|
|
|
Post by WrkrBee on Mar 15, 2024 7:50:41 GMT -5
Never seen drains installed like that. Must have been the guy's first day on the job and a non-camper. Should be able to cut around the lines and drop them a little. Check the valve handles. I lost one of mine and found another loose.
|
|
|
|
Post by skip12 on Mar 18, 2024 10:42:02 GMT -5
Never seen drains installed like that. Must have been the guy's first day on the job and a non-camper. Should be able to cut around the lines and drop them a little. Check the valve handles. I lost one of mine and found another loose. Thank you for the reply I didn't think they were put there from the factory. When it warms up I think I'm going to take the shield down and see what's really going on under there. I didn't think that was the proper location so I can relocate them to a reachable location . |
|
