Post by jenni on May 25, 2024 12:23:44 GMT -5
Hi,
It appears I have a pretty substantial leak. When I reopened the trailer after the winter, all of the carpet under the couch and table for the big slide and under the table of the bunkhouse slide was soaked. We recaulked what looked like it needed to be done and soaked up the water, but still leaking. Then noticed that under the bunkhouse slide, right in the front corner of it next to the large slide, there was sagging and the membrane was flaking away and the wood was soft.
We patched over that. And I cleaned and conditioned all of the seals. The wiper seal on exterior of the bunk room slide seemed to be not sitting completely flat in one section, so I did put some wood blocks on that to weight it down. I removed them after a couple of days.
It just rained and still leaking and most wet in that one spot again.
Does anyone have any suggestions? How can I pin It down?
I also took a picture of the model number on the slide frame but I don't know how to interpret it to figure out the type of slide (I wasn't sure if I needed to know the exact slide to get the rate seal to replace existing).
Thanks
It appears I have a pretty substantial leak. When I reopened the trailer after the winter, all of the carpet under the couch and table for the big slide and under the table of the bunkhouse slide was soaked. We recaulked what looked like it needed to be done and soaked up the water, but still leaking. Then noticed that under the bunkhouse slide, right in the front corner of it next to the large slide, there was sagging and the membrane was flaking away and the wood was soft.
We patched over that. And I cleaned and conditioned all of the seals. The wiper seal on exterior of the bunk room slide seemed to be not sitting completely flat in one section, so I did put some wood blocks on that to weight it down. I removed them after a couple of days.
It just rained and still leaking and most wet in that one spot again.
Does anyone have any suggestions? How can I pin It down?
I also took a picture of the model number on the slide frame but I don't know how to interpret it to figure out the type of slide (I wasn't sure if I needed to know the exact slide to get the rate seal to replace existing).
Thanks
